Connecting The Power Cord; Digital Connections; Digital Output Terminal; Digital Input Terminals - JVC RX-7030VBK Instructions Manual

• Digital Connections
This receiver is equipped with four DIGITAL IN terminals--one
digital coaxial lerminal and three digital oplical terminals--and one
DIGITAL OUT (oplical) terminal on the rear.
• For RX-8030VBK: Another digital oplical input lermina[ is
located on the front panel (see page 13).
IMPORTANT:
• When connecting a DVD player, digital TV broadcast tuner or DBS
tuner using the digital terminals, you also need to connect it to the
video jacks on the rear. Without connecting it to the video jacks, you
can view no playback picture.
• After connecting the components using the DIGITAL IN terminals,
set the following correctly if necessary.
- Set the digital input (DIGITAL IN) terminal setting correctly. For
details, see "Setting the Digital Input Terminals" on page 29.
- Select the digital input mode correctly. For details, see "Selecting
the Analog or Digital Input Mode" on page 19.
Digital outputterminal
You can connect any digital components which have an optical
digital input lerminal.
Digital optical cable (not supplied)
between digital optical terminals
\
When the digital recording
equipment such as an MD recorder _ ['- "]
and CD recorder has a digital _ |
optical input terminal, connecting it _ ] _ |
to the DiGiTAL OUT terminal I
enables you to perform digital-to- I I /
digital recording. J _-- umrrAL0trr_
qll
Digital input terminals
You can connect any digital components having coaxial or opiical
digital ouiput terminal.
Digital coaxial cable (not supplied)
between digital coaxial terminals
Digital optical cable (not supplied)
between digital optical terminals
--DIGITALIN_
optical _minal, connect it to the
DIGITAL 2
(CD),
DiGiTAL 3
(TV) or f
DIGITAL 4 (CDR) terminal, using a
digital optical cable (not supplied).
o yr C°2eeC2 tih ie
protective plug. [_ _
I
OiGITALI(OVD)
DIGITAL2{CO)
9IGITAL 3(TV)
OlGITAL4ICOR)
Note:
The digital signal format transmitted through the DIGITAL OUT
terminal is the same as that of the input signal This means that when
the DTS Digital Surround signals are input, the DTS Digital Surround
signals are transmitted.
Before plugging the receiver inlo an AC outlet, make sure thai all
connections have been made.
Plug the power cord into an AC outlet.
Keep the power cord away from the
connecting cables and the anlenna. The
power cord may cause noise or screen inlerference.
Note:
The preset settings such as preset channels and sound adjustment
may be erased in a few days in the following cases:
- When you unplug the power cord.
- When a power failure occurs.
CAUTIONS:
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the cord. When unplugging
the cord, always grasp the plug so as not to damage the cord.
Notes:
• When shipped from the factory, the DIGITAL IN terminals have
been set for use with the following components:
- DIGITAL I (coaxial): For DVD player
- DIGITAL 2 (optical): For CD player
- DIGITAL 3 (optical): For digital TV broadcast tuner
- DIGITAL 4 (optical): For CD recorder
• When you want to operate the CD player or CD recorder, (or MD
recorder: only for RX-803OVBK) using the COMPU LINK remote
control system, connect the target component also as described in
"Analog Connections" (see pages 12 and 13).
• When you want to operate a DVD player using the AV COMPU
LINK remote control system (see page 42), connect the DVD
player also as described in "Analog Connections" (see page 15).
16