Satellite Receiver - Sony BRAVIA KLV-40U100M Operating Instructions Manual

Connecting the Unit
Satellite Receiver
"_1° If you connect the Digital
Satellite Receiver with
component video cables,
see page 20.
This scenario shows a SAT Box connected through tile video inputs. Satellite
signals are selected by the SAT Box through the video inputs.
To connect a satellite receiver
1 Connect the satellite antenna cable to the satellite receiver's satellite
input jack.
2 Use an A/V and S VIDEO cables to connect the satellite receiver's
AUDIO and S VIDEO output jacks to the unit's AUDIO and S VIDEO
input jacks (VIDEO I or 2).
_ If your Satellite receiver is not equipped with S VIDEO, usea
VIDEO cable (yellow)instead of the S VIDEO cable.
s VIDEO cable
S VIDEO _,,,_,..... _
A/V cable
Rear of unit
VIDEO ................ ,,
(yellow) ,_
,,
AUDIO-L ........
(white) _ .........
AUDIO-R
(red)
Notes on Using This Connection
Watch the satellite receiver Press Vl or V2 on the remote control.
or
Press INPUT on the top panel repeatedly to select the satellite receiver input (Video
1 or 2).
Label video inputs to easily See the instructions t_r setting up Label Video Inputs on page 40.
identify equipment connected to
the unit
18