Basic Operations; Turning The Power On And Stand-By; Adjusting The Volume; Video Input Mode - Fujitsu Plasmavision P42VHA51W SERIES User Manual

BASIC OPERATIONS

TURNING THE POWER ON AND STAND-BY

* You can also use the buttons on
the display's control panel to
perform these steps.

ADJUSTING THE VOLUME

Adjusting the volume
Press
Press
* Note that the volume level remains stored even when you
Muting the audio
Press
The audio is removed.
Press again to restore the audio to the original level.
* You can also use the buttons on
the display's control panel to
The mute mode can also be released by pressing the volume buttons.
perform these steps.

VIDEO INPUT MODE

* You can also use the buttons on
the display's control panel to
perform these steps.
Note
• Functions may not be available with some models and some device options.
1
Press /I to the left at the bottom of the display to the ON
The power lamp lights up.
2
Press on the remote control.
The color of the power lamp changes from "Red" to "Green".
3
Press –
Select the video mode to input.
4
Press when the power is ON.
The color of the power lamp changes from "Green" to "Red" and the the power turns "OFF (Stand-
by state)".
to increase the volume.
to reduce the volume.
turn OFF the power.
.
1
Press -
mode.
You can select from VIDEO1 mode to VIDEO6
mode.
The video modes corresponding to each input
terminal are as follows.
• VIDEO1: Video
• VIDEO2: S-video
• VIDEO3: Component video
• VIDEO4: Component video
• VIDEO5: HDMI
• VIDEO6: HDMI (Model P42VHA** does not have this mode.)
* For selection of the input terminal, see "SETTING THE INPUT TERMINALS" on P. E-22.
or .
to select the input
When the volume adjustment button is
pressed
Video1 mode
state.
E-11