Display Codes - Haier HWD–C1000TXVE ME User Manual

18

DISPLAY CoDES

DISPLAY CoDES AND SPECIAL fUNCTIoNS
CoDES CAUSES
¬ Washer door is not properly shut . _ Shut the door properly
Err1
Err2 ¬ Drainage error . Water is not emptied
within 4 minutes .
Err3 ¬ Temperature sensor error .
Err4 ¬ Heater error or laundry overload . The set
temperature is not reached within specified
time . (Appears at the end of a cycle) .
¬ Water level not met within 8 minutes . _ Check the tap and the water pressure .
Err5
¬ Dehumidification/heating error . _ Please contact the Service Center .
Err6
Err7 ¬ Motor overheat error .
Err8 ¬ Water overflow .
¬ Error of the dryer temperature sensor . _ Please contact the Service Center .
Err9
Er10 ¬ Error of the water level sensor .
¬ Error of the dryer water level sensor . _ Check whether clothes are dry or not and whether there is
Er12
Er13 ¬ Dryer heater error .
¬ Laundry is unevenly distributed . _ Redistribute laundry to balance the drum .
unb
EUAr ¬ Communication error .
1:16 ¬ Status information: remaining program time is 1 hour and 16 minutes .
0:01 ¬ Status information: remaining program time is 1 minute .
60°C ¬ Status information: Wash temperature is 60°C .
--°C ¬ No heat (cold wash) .
0 ¬ No spin .
800 ¬ Status information: Spin speed 800 rpm .
L--1 ¬ Manually selected code when laundry weight is less than 1kg .
L--A ¬ Manually selected code when drum is nearly full .
End ¬ Program is finished .
¬ Control panel lock function: Press the "Delay" and the "Start/Pause" buttons simultaneously for 3 seconds after
starting a program . It can no longer be changed by operating buttons or knobs . The washing machine emits an audible
signal while the control panel is locked . To unlock press the "Delay" and "Start/Pause" buttons again for 3 seconds .
¬ Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program
cycle, the present settings will be saved and the preset operation will resume when the power is on again .
MAINTENANCE
SoLUTIoNS
_ Clean the filter and check the drain hose for blockage .
_ Please contact the Service Center .
_ Reduce load and start washing again .
_ Please contact the Service Center .
_ Please contact the Service Center .
_ Please contact the Service Center .
_ Please contact the Service Center .
_ Please contact the Service Center .
_ Please contact the Service Center .
Remove filter in case any water remains in the unit .
water still in the drum . If so allow excess humidity to
escape from the appliance and try the drying cycle again .