Sharp VL-Z1H Quick Start Manual

CAMCORDER QUICK START GUIDE
1 2
Attaching and
Removing the
Battery Pack
1
Attach the battery pack on the
Attaching
camcorder, and make sure that the
Power switch is set to OFF.
1
Make sure that the
2
Open the DC IN jack cover.
Power switch is set to
OFF.
2
Open the LCD monitor to a 90°
angle to the camcorder body.
3
Connect the supplied power cord
to the AC power socket on the AC
adapter, and insert the AC plug
into a power outlet.
90˚
3
Slide the battery pack in the
direction of the arrow with the "m"
mark facing out.
4
Insert the DC plug into the DC IN
jack of the camcorder.
• The POWER/CHARGE (RED)
"m" mark
4
Push the battery pack in the
direction of the arrow until it clicks.
• The POWER/CHARGE (RED)
Removing
Slide the battery release in the direction
of the arrow, and then take the battery
pack out.
Battery release
Web-site: www.sharp.co.uk/customersupport Help Line UK:08705 274277, Ireland:(01) 676 0648
3
Charging the Inserting and
Battery Pack Removing a Cassette
Inserting
1
Attach the power source to the
camcorder, then slide and hold
the cassette compartment door
release as you open the cassette
compartment door.
DC IN jack cover
Cassette compartment door release
2
Insert a commercially available
AC power socket
Mini DV cassette fully with the
window facing outwards, and
with the erasure protect tab
facing upwards.
Erasure protect tab
To power
outlet
SAVE
C E R
indicator lights up red.
POWER/CHARGE (RED)
indicator
3
Press the "PUSH" mark gently
until the cassette holder clicks
into place.
DC IN jack
DC plug
"PUSH" mark
indicator turns off when the battery
4
is charged.
Wait for the cassette holder to
fully retract. Close the compart-
ment door by pressing the centre
until it clicks into place.
Removing
Perform step 1 above, then take out the
cassette.
Please consult the supplied operation manual for further details on these and other functions of your camcorder.
4 5
Using the Lens
Cap
Attach the strap of the lens cap to the
1
Open the hand strap flap (1) and
hand strap as shown below.
grip strap (2).
When attaching or removing the lens
cap, grasp the indents on both sides of
the cap.
2
Loosen the grip strap, pass your
right hand through the hand strap,
and put your thumb close to the
Start/Stop button and your index
finger on the Power Zoom control.
Then, pull the grip strap tight until it
fits snugly.
Indents
When recording, remove the lens cap
and attach the lens cap cord to the
fastener so that the cap will not get in
the way.
3
Seal the Velcro
grip strap and the hand strap flap.
Fastener
6
Adjusting the Using the Grip
Hand Strap
Rotate the grip 135° forward or 90°
downward so that you can record
images easily from high or low angle.
135°
Grip strap
Hand strap flap
90°
Note:
• The grip cannot rotate when a tripod is
attached.
® fasteners of the
TINSEA063WJZZ
03P04-JKG