External Water Softening System - Miele G 1520 Operating Instructions Manual

External water softening
system
If your dishwasher is connected to an
external water softening system which
uses salt to reactivate, you will still need
to programme the dishwasher to the
correct water hardness level to achieve
good cleaning results.
Set the water softener unit of the
dishwasher to the water hardness level
of the water which is supplied from the
external water softening system. If you
do not know what this is, set the
dishwasher for 8°d (1.4 mmol/l).
^ Switch the dishwasher off with the
On/Off button s.
^ Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button s.
Keep the Start/Stop button pressed in
for at least four seconds until the
"Start/Stop" indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Delay start button twice.
The "Delay start" indicator will flash
briefly twice at intervals.
Before using for the first time
The number after the p in the display is
the water hardness level in °d (see
chart).
^ Use the Start/Stop button to select
the value which equates to the water
hardness level of the water supplied
by the external water softening
system.
Each press on the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
^ Switch the dishwasher off with the
On/Off button s.
If you disconnect the dishwasher
from the external water softening
system, set the value to P0.
15