Hourly Traffic Reports (Program 921)
TM, when ON, sends data each hour. The data is stored in the SD/SM card on the processor in a
TRAFFIC folder or it can be sent to an external device via LAN or RS-232. Each file is named:
MMDDHHNN.trf.
MM = Month (01 - 12)
DD = Day (01 - 31)
HH = Hour (01 - 24)
NN = Sequence Number
Traffic Measure
1. In eManager go to Utilities | Operations | Traffic Measure.
2. In the Traffic Measurement Tab
•
(FB01) Select On to run traffic measurement.
•
(FB02) Send TM Data to SM/SD Card - Set to Enable to send data to the SM/SD card
(TRAFFIC folder) and, if setup in I/O Device configuration, to an external device (RS232c
or LAN). Set to Disable to send data only to the external device. The external device must
be set (refer to the I/O Device configuration below).
•
(FB03) Select Tenant to Measure - This selects the System Day/Night Table to be used for
the Work Day and Non-Work Day and Holiday definitions. This does not select TM by
tenant.
•
(FB04 to FB12) Set the Time Zone (report hours) in each category.
•
Select the appropriate tab at the top of the page for (FB13, FB18 and FB19) Units (CCS or
Erlang), DTMF Receivers (Enable/Disable reports) and Conference Circuits (Enable/
Disable reports).
Select the other tabs to setup Outgoing Line Groups, Outgoing Line Groups, DID Lines
and DID Intercepts.
Strata CTX Application Implementation Vol 3
10/07
Traffic Measurement and Reporting
Hourly Traffic Reports (Program 921)
6-9