Starting Proset - NEC Express5800/320Ma Manual

•
Troubleshoot Ethernet PCI adapters (see
page 2-41).

Starting PROSet

To start the PROSet utility, use one of the following methods:
•
Double-click PROSet in the system tray:
•
Double-click PROSet in the Control Panel:
N O T E S
1. In systems with more than one enclosure, you can
physically remove an enclosure without disrupting the
network only if the active Ethernet PCI adapters in
the enclosure are teamed with adapters in another
enclosure. Note that with Adaptive Load Balancing
and Link Aggregation teams, your system will
experience a drop in throughput while the enclosure
is absent.
2. For fault tolerance, configure your Ethernet PCI
adapters into teams. Although Express5800/320Ma
systems support unteamed Ethernet PCI adapters,
an unteamed Ethernet PCI adapter is a single point of
failure that can cause the loss of a network
connection.
3. After you finish each configuration procedure using
PROSet, click Apply or OK in the Intel(R) PROSet
for Wired Connections dialog box (see
for an example of the dialog box) to preserve your
changes. If you do not click Apply or OK before
exiting PROSet, it cannot finish processing the
configuration procedure, and you must repeat the
procedure.
N O T E
Before starting PROSet, close the Local Area
Connection n Properties dialog boxes
all Ethernet PCI adapters; any open Properties dialog
box can cause problems for viewing and setting values in
PROSet.
Configuring Ethernet PCI Adapters
"Using PROSet Utility Diagnostics" on
Figure 2-3
(Figure 2-13) for
Ethernet PCI Adapters 2-7