3 ] Unpacking And Installation - Toshiba GA-1170 Service Manual

[ 3 ] UNPACKING AND INSTALLATION

The unpacking and set-up procedure shall be done by a qualified
service technician.
1. UNPACKING
2. PACKAGED GOODS
Parts included
Network
expansion kit
Screw (3 x 14) ... 1 pc.
USB cable ... 1 pc.
Clamp ... 1 pc.
CD-ROM ... 3 pcs.
Important
information ... 1 sheet
GA-1170 UNPACKING AND INSTALLATION
3 – 1
3. INSTALLATION PROCEDURE
This installation procedure is provided for e-STUDIO162/162D,
e-STUDIO151/151D.
For Installation to other models, see the operation manual of the main
unit or the service manual.
Turn off the main switch of the main unit and remove the power
plug of the copier from the outlet.
1. Cut the rear cabinet.
1) Remove the ADF/ RADF from the main unit and gently place it on
the document glass as shown in the illustration.
2) Cut out two cut-out portions from the rear cabinet using a cutter or
the like.
3) Use a Phillips screwdriver or the like to open a hole.
4) Remove the screw and then remove the rear cabinet cover.
5) Cut out a part of the rear cabinet cover with nippers or the like as
shown in illustration.
(Be careful about the orientation of the nippers so that the cross
section is flat.)
2. Attach the network expansion kit.
1) Engage the two pawls on the rear of the network expansion kit with
the cutout portions of the main unit and secure the kit with the sup-
plied screw (3 x 14).
2) Connect the connector of the network expansion kit to the connec-
tor of the main unit.
3) Secure the rear cabinet cover to the main unit with the screw.
4) Attach the ADF/ RADF to the main unit.