Loading The Bypass Tray With Paper - Sharp AJ-6000 Operation Manual

LOADING THE BYPASS TRAY WITH PAPER

If you wish to print on another paper type not loaded into the main paper tray, use the
bypass feed. Only one sheet of paper can be placed in the bypass tray at a time.
Open the bypass tray located on the rear of the unit.
1
Load the paper so that the side to be copied onto is face up.
2
Align the paper with the right side of the bypass tray.
When loading thick paper
Open the bypass tray until it reaches position 2 (the tray has two positions), set the
paper knob to the "Thick Paper (
Load the thick paper copy side up with the flap to the right, and then adjust the opposite
side to the right edge of the tray.
! The paper knob should always be set to the "Normal paper (
while printing on thick paper.
! After loading the different type or size of paper from previous ones, change the
corresponding settings referring to step 3 of "NORMAL COPYING". (See page 31)
The original image must be smaller than the paper in the tray. If the original image
is larger than the paper, this may cause smudges on the edges of the output and
may make the machine dirty inside.
22
)"setting.
Position 1
Position 2
)" setting except