Table of Contents
Advertisement
Using external equipment
Watching a decoder image
Connecting a decoder
You can use the INPUT 1 terminal when connecting a decoder and other audiovisual equipment.
44
AVC System (rear view)
COMPONENT
Y
P
(C
)
P
(C
)
B
B
R
R
INPUT 3
S-VIDEO
VIDEO
R - AUDIO - L
AV OUTPUT
MENU
Option
Input Select
Input 1
AV
RGB
INPUT SOURCE
TV
INPUT1
INPUT2
INPUT3
INPUT4
PC
INPUT 2
INPUT 1
SCART cable
(commercially available)
Displaying a programme
When connecting to the INPUT 1 terminal, select "Input
1" on "Input Select" in the menu to set the correct input
signal type. (See page 52.)
[AV]
The setting is stored and can be selected on the
"INPUT SOURCE" menu.
To watch a decoder image, select "INPUT1" from the
"INPUT SOURCE" menu using b on the remote
control unit or INPUT on the Plasma Display TV (Panel
Unit). (See page 52.)
A
• Each time b is pressed, the input source toggles.
• If the decoder image does not come in clearly, you may
need to change the input signal type setting on the "Input
Select" menu.
• It is recommended to connect to the INPUT 1 terminal
when using a decoder for ground wave signal input. If
INPUT 1 signals preset in auto installation or programme
setup, make sure to set "Decoder" to "INPUT1" in the
Programme Setup "Manual" menu. (See page 34.)
• Refer to your decoder operation manual for the signal type.
RS-232C
DISPLAY OUTPUT-1
DISPLAY OUTPUT-2
AC INPUT
220–240V
Decoder
Advertisement
Table of Contents
