Table of Contents
Advertisement
Preparation
Setting the system
1.
Connecting the system cable, the power cord and the speaker cables to the Plasma Display TV (Panel
Unit)
Plasma Display TV (Panel Unit) (rear view)
Speaker cable
(bottom view)
(WHITE)
A
• Two speaker cables of different lengths are supplied. As
shown in the diagram, connect the longer speaker cable
to the left speaker and the shorter to the right.
2.
Connecting the system cable and the power cord to the AVC System
AVC System (rear view)
L
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
POWER CORD CONNECTED.
Speaker cable
(GRAY)
System cable
(GRAYeGRAY with white stripe)
COMPONENT
Y
P
(C
)
P
(C
)
B
B
R
R
INPUT 3
S-VIDEO
VIDEO
R - AUDIO - L
AV OUTPUT
INPUT 2
Power cord
Red
Insert the speaker cable
Black
Speaker cables
(GRAY)
INPUT 1
Black
Red
As you apply pressure to this part,
insert the speaker cable. It is
important to match polarity when
connecting the speaker cables to the
terminals.
Lift up the snap clip.
Insert the wire into
the hole of the
connector.
Lower the snap clip
to grip the wire in
place.
System cable
(WHITE)
RS-232C
DISPLAY OUTPUT-1
DISPLAY OUTPUT-2
AC INPUT
220–240V
Power cord
11
Advertisement
Table of Contents
