Assign Interfaces To A Vlan - Dell Force10 S4810P Quick Start Manual

Assign Interfaces to a VLAN

Only interfaces in Layer 2 mode can be assigned to a VLAN using the tagged
and untagged commands. Use the switchport command to place an interface in
Layer 2 mode.
These Layer 2 interfaces can further be designated as tagged or untagged. When
an interface is placed in Layer 2 mode by the switchport command, the
interface is automatically designated untagged and placed in the Default VLAN.
To view which interfaces are tagged or untagged and to which VLAN they
belong, use the show vlan command. To view just the interfaces that are in
Layer 2 mode, enter the show interfaces switchport command in the EXEC
Privilege mode or EXEC mode.
To tag frames leaving an interface in Layer 2 mode, you must assign that
interface to a port-based VLAN to tag it with that VLAN ID. To tag interfaces,
use these commands in the following sequence:
Step Task
Access the
1
INTERFACE VLAN
mode of the VLAN to
which you want to
assign the interface.
Enable an interface to
2
include the IEEE
802.1Q tag header.
Use the untagged command to move untagged interfaces from the Default
VLAN to another VLAN:
Step Task
Access the
1
INTERFACE VLAN
mode of the VLAN to
which you want to
assign the interface.
18
Installing the Software
Command Syntax
interface vlan vlan-id
tagged interface
Command Syntax
interface vlan vlan-id
Command Mode
CONFIGURATION
INTERFACE
Command Mode
CONFIGURATION