Memory Problems; Modem Problems; Usb Device Problems; Pc Card Problems - Fujitsu LifeBook N6460 User Manual

L i f e B o o k N 6 4 0 0 S e r i e s U s e r ' s G u i d e
Problem

Memory Problems

Your Main menu of the
BIOS setup utility informa-
tion, does not show the
correct amount of installed
memory.

Modem Problems

Messages about modem
operation.

USB Device Problems

You have installed a USB
device, but your LifeBook
notebook does not recog-
nize the device, or the
device does not seem to
work properly.

PC Card Problems

A card inserted in the PC
Card slot does not work or
is locking up the system.
56
Possible Cause
Your memory upgrade module
is not properly installed.
You have a memory failure.
Messages about operation are
generated by whichever
modem application is in use.
The USB device is not properly
installed and/or powered.
The USB port is not enabled in
the BIOS.
The device is not properly
installed.
The device may have been
installed while an application
was running, so your notebook
is not aware of its installation.
Your software may not have
correct software driver active.
You may have the wrong I/O
address selected for your
device.
Your device and another device
are assigned the same I/O
address.
The card is not properly
installed.
Your software may not have
the correct driver active.
The card may have been
installed while an application
was running, so your notebook
is not aware of its installation.
You may have the wrong I/O
address selected for your PC
Card device.
Possible Solutions
Remove and reinstall your memory upgrade
module. (See Memory Upgrade Module page 45 for
more information)
Check for POST messages. (See Power On Self Test
Messages page 61 for more information)
See your application software documentation for
additional information.
Verify the USB is properly installed by unplugging
and replugging the plug. Also, verify that sufficient
power is available to the USB device.
Verify the USB port is Enabled in the BIOS. (See
Entering the BIOS Setup Utility page 27 for more
information)
Remove and reinstall the device. (See Device Ports
page 47 for more information)
Close the application and restart your LifeBook
notebook.
See your software documentation and activate the
correct driver.
See your device documentation and software docu-
mentation to determine the required I/O address.
Change the settings in the Device Manager.
Check all I/O addresses located within the Device
Manager and any other installed hardware or soft-
ware to make sure there are no duplications.
Remove and reinstall the card. (See Removing PC
Cards page 43 for more information)
See your software documentation and activate the
correct driver.
Close the application and restart your LifeBook
notebook.
See your PC Card documentation to determine
the required I/O address. Change the settings in
the Device Manager.