HP 240 Maintenance And Service Manual page 96

●
Fan/heat sink assembly (see
●
Processor (Intel only; see
NOTE:
replaced.
To remove the system board:
1. Close the computer, turn it upside down, and then disconnect the optical drive connector cable
from the system board.
2. Turn the computer back over, open it, and then remove the two Phillips PM2.5×4.0 screws (1)
that secure the system board to the base enclosure.
88 Chapter 4 Removal and replacement procedures
Fan/heat sink assembly on page
Processor on page
AMD processors come soldered to the system board and cannot be removed or
92)
98)