Feed Roller Parts - Dell 1815 Mono Laser Service Manual

5.23 Feed Roller Parts

1. Before you remove the Feed Roller Parts, you should
remove:
- Pick Up Roller Ass'y (Refer to 5.17)
- Duplex Guide Housing (Refer to 5.18)
- Middle Cover Ass'y (Refer to 5.20)
- MPF Housing (Refer to 5.22)
2. Remove the two screws securing the both side of the
Guide Paper and then remove the Guides.
Guide Paper
3. Pull up the Feed Idle Shaft and the Bushs (with
Spring).
Feed Idle Shaft
Srring
Bush
4. Release the E-Ring securing the Feed2 Gear and
remove it.
E-Ring
Feed2 Gear
5. Remove the three screws securing the Feed Bracket
Unit and then remove the Feed Bracket Unit and
Feed2 Shaft.
Feed Bracket Unit
Feed2 Shaft
Precautions
Service Manual
5-31