Panasonic AG-CPDIOCRUP Operating Instructions Manual page 24

Factory default settings
8 V-CH
9 AUDIO2
10 Pre Time
11 Post Time
12 Power On/Off
13 P-Rec
14
GPIO
GPIO On/Off
DETECTION
Name
Setup
Printable
15 AUDIO2 REC
When set to "0", the recorder will perform shutdown after about one minute.
1
24
(continued)
1 Video input
Setting values1: Camera cable connector input
MIC Audio input
Setting values: AUDIO IN2
(For information on audio settings, see page 18.)
120 Prerecord time (seconds)
Setting values: 0 - 180
120 Post-record time (seconds)
Setting values: 0 - 180
120 Time lag between SIGNAL off and
recorder shutdown (minutes)
Setting values: 0 - 180
OFF Automatically start recording at SIGNAL ON
Setting values: ON
Settings for GPIO ports 1 - 8 (common to all ports)
ON Enable/disable global GPIO
Setting values:
H Individual trigger settings for GPIO 1 - 8
Setting values: N (No input)
---- GPIO 1 - 8 names
ON Individual OSD display settings for GPIO 1 - 8
Setting values: ON (OSD on)
- OSD character string for GPIO 1 - 8
ON Audio R-CH recording
Setting values: ON
2: VIDEO IN connector input
MIC
OFF
ON (Globally enable GPIO input)
OFF (Globally disable GPIO input)
H (High-edge trigger)
L (Low-edge trigger)
B (Both-edge trigger)
OFF (OSD off)
OFF
1