Removing The Processor Thermal-Cooling Assembly; Replacing The Processor Thermal-Cooling Assembly - Dell Studio 1535 Service Manual

Back to Contents Page
Processor Thermal-Cooling Assembly
Dell™ Studio 1535/1536 Service Manual

Removing the Processor Thermal-Cooling Assembly

CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1. Follow the instructions in Before You
2. Turn the computer over and remove the base cover (see
3. In sequential order (indicated on the thermal-cooling assembly), loosen the four captive screws on the thermal-cooling assembly processor cover.
4. Loosen the two captive screws on the thermal-cooling assembly sink.
5. Disconnect the thermal-cooling assembly fan cable from the connector on the system board.
6. Remove the screw from the thermal-cooling assembly fan and take out the thermal-cooling assembly.
1 thermal-cooling assembly sink
3 thermal-cooling assembly processor cover 4 thermal-cooling assembly fan

Replacing the Processor Thermal-Cooling Assembly

CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1. Align the four captive screws on the processor thermal-cooling assembly processor cover with the screw holes on the system board and tighten the
screws in sequential order.
2. Tighten the two captive screws securing the thermal-cooling assembly sink to the system board.
3. Replace and tighten the screw to secure the thermal-cooling assembly fan to the system board.
4. Connect the thermal-cooling assembly fan cable to the system board.
5. Replace the base cover (see
Back to Contents Page
Begin.
Removing the Base
2 fan cable
Replacing the Base Cover).
Cover).