Replacing The Palm Rest - Dell Studio 1535 Service Manual

1 screws (8) 2 fingerprint reader connector
3 touch pad connector 4 speaker connector
9. Moving from left to right, carefully lift the palm rest along the rear edge, near the hinge brackets, then gently lift the palm rest to remove it from the
computer.

Replacing the Palm Rest

CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1. Align the palm rest with the base of the computer and gently snap it into place.
2. Connect the touch pad, fingerprint reader, and speaker connectors to the system board.
3. Replace the eight screws on the palm rest.
4. Replace the display assembly (see
5. Replace the mini cards (see
6. Replace the eight screws at the bottom of the computer.
7. Replace the base cover (see
Back to Contents Page
Replacing the Display Assembly).
Replacing the Mini-Card).
Replacing the Base Cover).