Detection Area Of The Transmissive Sensor; Detection Area Of The Reflective Sensor - Toshiba B-EV4 Series Manual

1. OUTLINE
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC approved media.
2. When using a media roll of 76.2-mm (3") inner core diameter, the 3"-Diameter Media Shaft included in
the optional External Media Roll Hanger is required.
3. Precaution for use of labels
When labels are used for printing, please only use outside wound labels.
Use of an inside wound label causes a paper jam.
Label
Tag Paper

1.5.2 Detection Area of the Transmissive Sensor

The Transmissive sensor is fixed and positioned at 6.35 mm right of the center of the media path.
The Transmissive Sensor detects a gap between labels, as illustrated below.
Sensor position
Min. 2 mm
(Min. 6 mm:
cut mode)

1.5.3 Detection Area of the Reflective Sensor

The figure below illustrates the relation between the head effective print width and media width.
(for GS14 Type)
Out of print range
(for TS14 Type)
Out of print range
Outside wound
Usable
Usable
Area to be detected.
Label
Gap
Label
Min. 8 mm
Print head element
108.0 mm±0.2mm
2 mm
(Head Effective Print Range)
112.0 mm (Max. media width)
Print head element
106.0 mm±0.2mm
3 mm
(Head Effective Print Range)
112.0 mm (Max. media width)
Inside wound
Not usable
Usable
6.35mm
2 mm
3 mm
1-10
1.5 Supply Specifications
Sensor position
Print side
Media feed direction
Out of print range
Out of print range
EO18-33025