Philips CED228/58 Quick Start Manual

Register your product and get support at
CED228
ENG Quick Start Guide
English
Overview of parts
These are the supplierd parts needed to connect and install this unit.
a
b c
d e f
a Carry case with front panel stored inside
b Trim plate
c Standard connector
d Rubber cushion
e Removal keys x 2 pcs
f Screw x 5 pcs
Connect wires: ISO connectors
1
Pull out the ISO connectors from the
car dashboard and connect them to
the bigger end of the supplied standard
connector.
2
Connect the other end of supplied
standard connector to the unit.
3
Do the other connections, if applicable.
Connect wires: without ISO connectors
8
1
2
7
3
4
6
5
1
Cut off the bigger end of the supplied standard connector.
2
Check the car's wiring carefully, then connect them to the standard connector.
Connector Connect to
1
Black wire A metal surface of the car
First connect the black ground (earth) lead, then connect the
yellow and red power supply leads.
2
Yellow wire The +12V car battery which is live at all times.
3
Orange/white wire Illumination switch
4
Red wire The +12V power terminal which is live in the accessory
(ACC) position of the ignition switch
If there is no accessory position, connect to the +12V car bat-
tery terminal that is always live. Be sure to connect the black
ground (earth) lead to a metal surface of the car first.
5
Green and green/black wires Left speaker (Rear)
6
White and white/black wires Left speaker (Front)
7
Gray and gray/black wires Right speaker (Front)
8
Purple and purple/black wires Right speaker (Rear)
3
Connect the supplied standard connector to the unit.
4
Do the other connections, if applicable.
Connect parking brake cable
Connect reverse driving cable