Advertisement
Power S upply Cord
Direct W ire
Fire Hazard
Use a new UL misted 30 amp power supply cord.
Use a UL misted strain retief,
Disconnect
power before making emectrical connections,
Connect neatraB wire (white or center wire) to center
terminal
(silver),
Ground wire (green or bare wire) must be connected
to
green ground connector.
Connect remaining
2 suppmy wires to remaining
2 terminals
(gored).
Securemy tighten
aimelectrical
connections,
Failure to de so can resumt in death, fire, or
electrical
shock,
1. Disconnect power.
2. Remove the hold-down
screw and terminal block cover.
h
....
•
•
•
j
A
A. Center silver-colored
terminal block screw
B. Hold-down
screw
C. Terminal block cover
D. Internal ground conductor
screw
Fire Hazard
Use 10 gauge somid copper
wire,
Use a UL misted strain
relief,
Disconnect
power before making emectricaJ connections.
Connect neutral wire (white or center wire) to center
terminal
(simver).
Ground wire (green or bare wire) must be connected
to
green ground connector,
Connect remaining
2 suppmy wires to remaining
2 terminals
(gold).
Securety tighten
aimeBectrica{ connections.
FaiJure to do so can resuJt in death, fire, or
emectrical shock.
3. Assemble a 3/4"(1.9 cm) UL listed strain relief (UL marking on
strain relief) into the hole below the terminal block opening.
Tighten strain relief screws just enough to hold the two clamp
sections together, Put power supply cord through the strain
relief, The strain relief should have a tight fit with the dryer
cabinet.
Now complete installation following instructions for your type
of electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Advertisement
