GE 49-90331 Installation Instructions Manual page 3

Installation Instructions
MOVING SPACEMAKER'" TO OPERATING
LOCATION
r_ Remove 2 screws securing access panel
the the
to the dryer cabinet. Lift the front access panel
until the tabs can be disengaged from the dryer
cabinet and remove the panel.
rl_l Route the inlet drain hose and cord
hoses,
power
through the rear access area for temporary
holding when moving the appliance to the
operating location.
panel
screws
r_To ensure the LaundryCenter is level and solid
on all four legs, tilt the Laundry Center forward
so the rear legs are off the floor. Gently set the
Laundry Center back down to allow the rear legs
to self adjust. Place a level on top of the washer.
Check it side to side, then front to back. Screw
the front leveling legs up or down to ensure the
Laundry Center is resting solid on all four legs
(no rocking of the Laundry Center should exist).
NOTE: Keep the leg extension at a minimum to prevent
excessive vibration.
CONNECTING TO PLUMBING FACILITIES
CAUTION: Be sure water supplg lines have been
thoroughlg flushed to remove particles that might
clog the washer filter screens.
r_ Check inlet hoses to insure the rubber washers
are installed in each end. (If your laundry center
has the hoses attached to the water valve,
proceed to Step !3A.) Carefully connect the inlet
hoses to the water valve (on the left side of the
washer cabinet), tighten by hand, then tighten
another 2/3 turn with pliers.
CAUTION: DO NOT CROSSTHREAD OR
OVERTIGHTENTHESECONNECTIONS.
Determine which water faucet is the HOT water
faucet and carefully connect the bottom inlet
hose to the HOTwater faucet, tighten by hand,
then tighten another 2/3 turn with pliers.
Carefully connect the top inlet hose to the
COLD water faucet, tighten by hand, then
tighten another 2/3 turn with pliers.
CAUTION: DO NOT CROSSTHREAD OR
OVERTIGHTENTHESECONNECTIONS,
Turn the water on and check for leaks
at both connections.
Place formed end of drain hose in drain facility
and secure with cable tie (provided in literature
package).
\
Cord length
4 ft.
"Cable tie
tie
33" Min./
96" Max.
<
NOTE:
Drain hose MUSTbe secured to drain facility in
all cases.