GE 49-90331 Installation Instructions Manual page 4

Table of Contents

Advertisement

Installation
Instructions
CONNECTING
TO GAS SUPPLY
r_l
Connect
gas supply to
dryer.
the
the
If codes
allow, use new flexible metal tubing (design
certified by the American Gas Association). Be
sure there are no kinks. For gas connections, you
MUSTuse pipe joint compound resistant to the
action of LP gas.
CAUTION: Be sure electricitg is OFF at power
supplg source (circuit breaker/fuse box).
[_-_
Plug
cord
electrical outlet.
power
into
IMPORTANT:
120 volt 60 hz AC only electrical supply is
required on a separate 15 ampere circuit fused by a time
delay fuse or circuit breaker.
NOTE: Do not, under
ang circumstances,
remove
grounding
prong from
plug.
Grounding
prong
FINAL APPLIANCE LEVELING
CAUTION: ALL WEIGHT MUST BE REMOVEDFROM
APPLIANCE LEVELING LEGWHILE ADJUSTING.
THREADS ON LEG WILL BE DAMAGED OTHERWISE.
r_
Again, make sure the appliance rests firmly on
all four legs. No rocking of the appliance should
exist.
CHECKING APPLIANCE OPERATION
r_
Make sure
packing
shipping
are
all
and
materials
removed, including the washer shipping bolt and
plastic spacer block.
Make sure the drain hose is properly routed-not
coiled or kinked.
r -e]
Hake sure water inlet hoses are connected (HOT
to HOT)and tightened securely without kinks.
Turn on water faucets and check for leaks.
Tape all joints to make sure exhaust ductwork is
secured without leaks.
Turn on electricity at the power source.
Turn on the washer and dryer and run through
one cycle. Check all hoses for leaks. Ensure the
burner has lit.
NOTE: Before the burner will light, it is necessary for
the gas line to be bled of air. If the burner does not light
within 45 seconds the first time the dryer is turned on,
the safety switch will shut off the burner. If this happens,
turn the timer to "OFF" and wait 5 minutes before
making another attempt to light.
REPLACING FRONT ACCESS PANEL
r_
Reinstall
safety cover
access panel.
the
and front
r_
place the Owner's Manual and Installation
Instructions in a location where they can be found
by the customer.
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Spacemaker wsm2780

Table of Contents