D6610 Cpu Card And D6615 Cpu Terminator Card - Bosch Conettix D6600 Installation And Operation Manual

22 en | D6600 Specific Cards
2.
3.
4.
5.
6.
7.
D6640/D6641 Telephone Line Monitoring
Each line on the line card continuously monitors the telephone line voltage whether on-hook
or off-hook. If the voltage on a line falls below 1.8 VDC a Line Trouble indication is generated
and when it rises above 2.5 VDC it generates a restoral for this line.
6.3

D6610 CPU Card and D6615 CPU Terminator Card

The CPU card connects to the user interface on the front of the D6600 using a 50-pin ribbon
cable socket.
Figure 6.4: D6615 CPU Terminator Card
Callout ᅳ Description
1 ᅳ Alignment Guide - Stabilizes the connection and acts as a guide for connecting the
terminator card to the CPU card.
2 ᅳ COM3 Automation Computer Port - An auxiliary RS-232 port for connecting to a
computer terminal or an automation computer. For SIA/6500 Mode Automation Format
reporting, use a null-modem cable to connect to a computer.
3 ᅳ COM4 RS-232 Port - Connection to a computer running the D6200 programming
software.*
2012.11 | 08 | 4998122704
Open the display door on the D6600. One telephone line card is installed in the D6600
when the unit is shipped from the factory.
Insert the new line card into the slot by aligning the top and bottom of the line card with
the card guides in the D6600 chassis. Firmly push the card to make sure it is fully
connected.
If you are installing a new telephone line card, remove the appropriate snap-in covers
from the front of the panel.
Close the front panel.
Program the line card if necessary.
When the line card is initialized (as indicated by a printer report), the settings in the line
card programming section automatically load into the card.
Connect communication lines to the line card.
Installation and Operation Guide
Conettix Communications Receiver/
Gateway
Bosch Security Systems, Inc.