GE Everest Ca-Zoom 6.2 Operating Manual page 79

78
• Locate the laser power harness and unplug from the circuit board by gently pulling on the
wires (fig. 55)
• Gently pull harness to the right side of the housing out of the way.
Figure 55
• Pull the module out through the back of the camera housing (fig. 57).
• As the module is removed, pull to the left to clear the internal wiring.
• Make sure the internal wiring is tight along the sides of the housing before inserting a new
module (fig. 58).
Figure 57
• Reconnect the video harness, the power harness (right 4-pin connector) and the laser harness
(left 4-pin connector)
• Replace cover and tighten screws hand-tight.
• Pressure test camera housing. See "Pressure Testing" section on page 82.
®
Everest Ca-Zoom 6.2
Figure 56
Figure 58