Kenwood TM-D710A (K type) Instruction Manual page 40

Command Name Short
TRFLOW TRF
TRIES TRI
TXDELAY TX
TXFLOW TXF
UICHECK UIC
UIDIGI UI
UIDWAIT UIDW
UIFLOOD UIF
UISSID UIS
UITRACE UIT
UNPROTO U
USERS US
WRITE W
XFLOW X
Description
When ON, causes the TNC to respond to software
flow control from the computer in Transparent mode.
Specifies the number of transmission retries
programmed in the retry counter.
Specifies the time delay between PTT ON and start
of transmission. The unit of the parameter is 10
milliseconds.
When ON, allows the TNC to send a software
flow control (XON and XOFF) to the computer in
Transparent mode.
Does not forward the same UI packet as one received
within the time specified by this command. The unit of
the parameter is 1 second.
When receiving a UI packet which includes the
parameter specified by this command, replaces the
parameter with the MYCALL parameter and forwards
the packet.
When ON and digipeating, causes the TNC to use the
DWAIT and PPERSIST settings.
Specifies how received UI packets, which include
WIDEN-N or TRACEN-N parameters, are processed.
Enter WIDE or TRACE before ID, NOID, or FIRST; ex.
WIDE,FIRST. With ID selected, deletes the relayed
digipeaters and adds the MYCALL parameter. With
NOID, merely decrements N-N; ex. 4-3 to 4-2. With
FIRST, adds the MYCALL parameter only when
serving as the first digipeater.
When ON, causes the TNC to process received UI
packets depending on included destination SSIDs.
The command name must be followed by up to 5
alphanumeric characters; normally WIDE or TRACE.
Causes the TNC to forward received UI packets which
include WIDEN-N or TRACEN-N parameters.
Specifies callsigns to send a packet in Unprotocol
mode. Call1 is the callsign of the destination. Call2 to
call9 are callsigns of stations to be digipeated through.
Specifies the number of channels available to connect
requests.
Allows the TNC mailbox to store your message.
In order to permit only a specific station to read
your message, enter a callsign after the command
name; ex. W JA1YKX. To complete message entry,
press [Enter] (or [Return]), [Ctrl]+[C], then [Enter]
(or [Return]). For a subject, you can enter up to 30
alphanumeric characters.
Causes the TNC to perform software flow control when
ON, or hardware flow control when OFF.
PACKET-7
Parameter Default
ON/ OFF OFF
0 ~ 15
0 ~ 120
ON/ OFF OFF
0 ~ 250
OFF/
ON Call1, ... OFF
call14
ON/ OFF OFF
ID/ NOID/ FIRST
ON/ OFF OFF
−
Call1 (VIA call2,
CQ
call3
0 ~ 10
−
ON/ OFF ON
0
50
28
ID
−
1
−