Kenwood TM-D710A (K type) Instruction Manual page 64

When using the optional VGS-1 voice guide & storage unit, you gain access to the voice recorder and voice
announcement functions. <The VGS-1 is sold depending upon area.>
VOICE ANNOUNCEMENTS
When changing modes, frequencies, settings, etc., an audio
voice will announce the new information.
• Voice announcements are output from the PTT band side.
1 Enter Menu mode and access Menu 003.
2 Set the announcement function to MANUAL, AUTO, or
OFF.
• Refer to the tables below for announcements based on
settings.
MANUAL:
A microphone PF key must be programmed as [VOICE] to
use MANUAL voice announcement.
Operation
While in VFO Press [VOICE]:
mode Operating band frequency
Press [VOICE]:
While in MR mode "Channel" + Channel number +
operating band frequency
Press [VOICE]:
While in Call
"Call channel" + operating band
mode
frequency
Press [VOICE]:
While in Menu Menu number or setting value
mode (some selections have no voice
announcement)
Tone frequency Press [VOICE]:
setup "Tone frequency" + frequency value
CTCSS frequency Press [VOICE]:
setup "CTCSS frequency" + frequency value
Press [VOICE]:
DCS code setup
"DCS" + code value
VGS-1 (OPTIONAL) OPERATION
Announcement
AUTO:
Announcements are made automatically when changing a
mode/frequency/setting.
Operation
Press [VFO]
Press [MR]
Press [CALL]
Press [MENU]
Press [F]
Press [PM]
Press [ENT]
Change the
operating band/
turn the power ON
Change the
frequency band
Setting up the PM
Frequency direct
entry
Memory Direct
Entry mode
Press [F], rotate
Tuning control
Press [F], [M.IN] in
VFO mode
Press [A/B] in
VFO mode
Press [F] and then
the Tuning control
in VFO mode
Select Menu
number in
category
Select setting
value in Menu
mode
Clearing a
memory channel
Perform a Full
Reset
Perform a Partial
Reset
Perform a VFO
Reset
Perform a PM
Reset
VGS-1
Announcement
"VFO"
"MR"
"Call"
"Menu" + menu number
"Function"
"PM"
"Enter"
"A"/"B" + "Channel" (for MR only) +
"Call"/channel number + "Channel"
(for CALL only) + operating band
frequency + output power level
New receive frequency
Channel number/"Off"
Entered key number
Channel number
On stored channel
"Memory in" + channel number +
frequency
On blank channel
"Memory in" + channel number +
"Blank"
"A"/"B" + frequency + output power
level
"Menu" + "Mode" + The main Menu
number corresponds to the first digit.
(For example, "5" is Menu No. 5xx.)
"Menu" + menu number
Setting value
"Memory"+ channel number + "Clear"
"Full reset?"
"Partial reset?"
"VFO reset?"
"PM reset?"