Operating Instructions - Fujitsu MCM1514V Service Manual

This procedure gives you instructions for installing and using the 154V/C551 Series display.
1. Position the display on the desired operation and plug the power cord into a convenient AC outlet. Three-wire power cord must be
shielded and is provided as a safety precaution as it connects the chassis and cabinet to the electrical conduit ground. If the AC
outlet in your location does not have provisions for the grounded type plug, the installer should attach the proper adapter to ensure a
safe ground potential.
2. Connect the 15-pin color display shielded signal cable to your signal system device and lock both screws on the connector to ensure
firm grounding. The connector information is as follow:
1
6
11
PIN NO.
1.
2.
3.
4.
5.
6.
7.
8.
3. Apply power to the display by turning the power switch to the "ON" position and allow about thirty seconds for display tube warm-
up. The Power-On indicator lights when the display is on.
4. With proper signals feed to the display, a pattern or data should appear on the screen, adjust the brightness and contrast to the most
pleasing display.
5. This monitor has power saving function following the VESA DPMS. Be sure to connect the signal cable to the PC.
6. If your 154V/C551 Series color display requires service, it must be returned with the power cord.

3. OPERATING INSTRUCTIONS

5
10
15
DESCRIPTION
RED
GREEN
BLUE
GND
GND
GND-R
GND-G
GND-B
15 - Pin Color Display
Signal Cable
PIN NO.
9. NC
10. GND
11. SYNC. GND
12. SDA
13. HORIZ. SYNC
14. VERT. SYNC (* VCLK)
15. SCL
DESCRIPTION