Rack/Mast Mounting; Table 2-1. Hardware Preparation Items - Motorola XR900 Series User Manual

Hardware Preparation and Installation
2
!
Caution
Setting jumper options on drive modules
used in this chassis (as required)
Installing drive modules
Installing external cables (as required)
Mounting chassis in rack, on mast, or on
pedestal

Rack/Mast Mounting

2-2
Unless otherwise instructed, perform all hardware
preparation and/or installation with power
disconnected. Installing or removing hardware items
(drive modules, cables, etc.) while power is applied may
damage the equipment.

Table 2-1. Hardware Preparation Items

Item
The XR900 chassis, like other Modular Chassis system enclosures,
can be installed without modification in a standard 19-inch RETMA
(or equivalent) equipment rack. With minor modifications, it can
also be installed on a 19-inch mast (as in telecommunications
installations), or in a 23-inch rack or mast. The procedure is the
same in all cases. To rack- or mast-mount the chassis, proceed as
follows:
1. Remove the blank bezel from the desired rack mounting
location, if a bezel is installed.
2. Remove the bezel from the XR900 chassis, if a bezel is
installed.
Location of Instructions
User's manual for the respective drive module(s)
User's manual for the respective module(s)
Installation instructions in this manual, also other
user's manual(s) as applicable
Installation instructions in this chapter