Table of Contents
Advertisement
Open the LCD panel approximately half way. Remove the left and right inside caps by
5.
carefully pushing each cap towards the middle of the notebook until it pops off the top
cover assembly. The caps are held tightly in place by three internal tabs.
Unplug the following top cover assembly cables from the main board.
6.
Unplug the speaker cable from connector P18 on the main board. (The speaker is
!
fastened to the underside of the top cover.)
Release the cable locks on connectors P9 and P10 on the main board and unplug the
!
two VersaGlide Touchpad cables from the connectors. Remove and save the tape
holding the two cables.
Remove the six screws securing the top cover assembly.
7.
A – Round Head Screws (4)
Carefully lift a corner of the top cover assembly to unsnap it from the base. Slowly work
8.
around the cover, carefully unsnapping a small portion of the cover at a time.
When reassembling, be careful to align the top cover assembly with the base so that the
power slide switch is positioned against the inside wall of the base.
3-8 Disassembly and Reassembly
Removing the inside cap
A – Left Inside Cap (right side similar)
Removing the top cover assembly screws
B – Flat Head Screws (2)
Hide quick links:
Advertisement
Table of Contents
