GE SymVeo SV-XP1 User Manual page 16

10 SymVeo IP Camera
User Manual
To make the camera work in your network you must supply the
camera with a network specific IP address, Subnet mask and
Gateway address. These numbers should be obtained from your
network administrator or IS professional. The IP and other
addresses on the SymVeo can be changed in one of three ways,
using the supplied RS232 cable, or using the SymVeo's On
Screen Display (OSD) with an analog monitor, or using the Web
browser feature. Please look below to see which method you
should use to change the addresses on your units.
Methods for changing the IP address on the SymVeo
PAL users - First time
Follow the Using the supplied RS232 Cable method for
changing the IP address. See the PAL Installation section for
more information.
PAL users - Subsequent times
After the initial setting of the IP address, any of the three methods
(RS232 Cable, On Screen Display, or Web Browser) may be
used to change the IP address.
NTSC users - First time
Follow the Using the supplied RS232 Cable or the Using the
On Screen Display (OSD) methods for changing the IP address.
NTSC users - Subsequent times
After the initial setting of the IP address, any of the three methods
(RS232 Cable, On Screen Display or Web Browser) may be
used to change the IP address.