Alternative Management Methods - GE MDS SD Series Technical Manual

Using the Remote
Management Wizard
Getting an Overview
of Radio Settings
32
Figure 24. Basic Setup Wizard
5. At the conclusion of the wizard, click
complete for the connected radio. Log out of the Device Manager by
clicking in the upper right hand side of the screen. If desired,
Logout
you may proceed with the additional functions described below.
To program the key settings of Remote radios installed in the wireless
network, select
Setup Wizards>>Remote Management
Radio and follow the prompts contained in that tool. At the conclusion
of the wizard, click
Commit Configuration
figuration is now complete.
To get a top-level view of the key settings and operating parameters for
the radio, select
Overview
finished, log out of the Device Manager by clicking
right hand side of the screen.

Alternative Management Methods

The following methods are for use where web-based management is not
available:
• Serial—(
COM1
method of control commonly used on earlier GE MDS radios.
• Telnet—(
ETHERNET
the same capabilities as Serial control, but may be performed
either through a local connection, or over a network.
For more information on alternative management methods, refer to the
SD Serial/Telnet Management Supplement, Part No. 05-6193A01, avail-
able from the GE MDS website at
SD Series Technical Manual
Invisible place holder
Done
, followed by
and a summary screen will be displayed. When
DB9 connector). This is the "console terminal"
RJ-45 connector). Telnet offers essentially
www.gemds.com
. Configuration is now
from the AP or Master
. Remote con-
Done
in the upper
Logout
.
MDS 05-4846A01, Rev. H