Table of Contents
Advertisement
TOOLS REQUIRED FOR ASSEMBLY
(1)
Pliers
(2)
7/16" Wrenches
(2)
1/2" Wrenches
(2)
9/16" Wrenches
reMOVaL OF parts FrOM cartON
Remove all parts and hardware packages from the
carton. Lay out all parts and hardware and identify using
the illustrations on pages 3.
STEP 1: (SEE FIGURE 1)
•
Turn the spreader upside down.
•
Remove the lock nut from the middle bolt in the
crossover tube and shaft support plate. Leave the bolt
in place.
•
Assemble the hitch tube onto the middle bolt and
secure it with the same lock nut you removed. dO
NOt tIGHteN Yet.
HITCH
TUBE
FIGUre 1
ASSEMBLY
MIDDLE BOLT
4
STEP 2: (SEE FIGURE 2)
Assemble the OUter hitch braces to the hitch tube
•
using a 1/4" x 1-3/4" hex bolt and a 1/4" nylock hex
nut. dO NOt tIGHteN Yet. Do not assemble the
inner hitch braces at this time.
1/4 NYLOCK
NUT
FIGUre 2
STEP 3: (SEE FIGURE 3)
•
Assemble a spacer, a washer, a wheel (air valve
facing out) and another washer onto the end of the
axle that has only the small hole.
•
Install a 1/8" x 1-1/2" cotter pin into hole in the axle.
FIGUre 3
1/4 x 1-3/4
HEX BOLT
SPACER WASHER
WASHER
1/8 x 1-1/2
COTTER PIN
WHEEL
Advertisement
Table of Contents
