Further Setting Possibilities - Silvercrest SKRP 1000 A1 Operating Manual

Press the button MODE/LOCK k to save the
menu settings and to close it down.

Further setting possibilities

Setting the display brightness
Press the button LIGHT/DIMMER j repeat-
edly to set the brightness level at which the
display should be illuminated. The brightness
can be set at 3 levels.
Illuminated clamp strip
Documents, for example recipes, with a width
of up to 10 cm can be inserted and automati-
cally held in the clamp strip d. If you press
and hold the button LIGHT/DIMMER j for
two seconds, the downward facing lamp is
switched on, which then illuminates the recipe.
Press and hold the button j once again for
two seconds to switch the lamp off.
Kitchen timer
1. Press the button TIMER s.
2. Using the buttons UP
set the desired time interval (a time span
between 1 minute and 23:59 h is pos-
sible). Pressing and holding one of the
buttons changes the display in ten-minute
intervals. Or press one of the buttons
M1–M4 t–i to recall a saved preset
time for the kitchen timer. The following
times are factory pre-programmed:
Button M1 t = 5 min. (Indicator = T1)
Button M2 y = 10 min. (Indicator = T2)
Button M3 u = 15 min. (Indicator = T3)
Button M4 i = 20 min. (Indicator = T4)
3. Press the button TIMER s once again to
start the kitchen timer. In the display r a
clock icon running in reverse and a cook-
ing pot symbol appears.
4. From 30 seconds before expiry of the time
span an acoustic signal sounds, repeating
at shorter intervals the closer the set time
approaches. When the time has expired,
the alarm sounds continuously and with
increasing volume.
5. Press any button to stop the alarm, even if
the button lock is switched on .
/DOWN
 
1(/l,
Interrupting the kitchen timer.
• To interrupt the kitchen timer, switch to the
kitchen timer mode by pressing the button
TIMER s.
• Then briefly press the button TIMER s to
interrupt the kitchen timer.
The time is halted, the indicator blinks for
10 seconds. After this period the appliance
returns to automatic modus. To restart the
kitchen timer, briefly press the button TIMER
s again to switch back into the kitchen timer
mode.
• Press the button TIMER s once again. The
time then continues to run.
• To completely switch the kitchen timer off,
press and hold the button TIMER s for 3
seconds The clock and cooking pot sym-
bol disappear.
Programming the kitchen timer
You can programme frequently used times for
the kitchen timer into the appliance, so that
you do not need to enter them in repeatedly.
As the appliance can be used by several
people, it has user switching, A/B. Both users
can save 4 different timer periods each.
1. First, select the desired user. To switch
between users, press and hold the button
USER/BAND h for two seconds.
2. Then press the button TIMER s.
3. Using the buttons UP
enter in the desired time.
4. Press the button MEM/AMS o. On the
right and next to the time indicator, "T"
lights up.
5. Press one of the pre-set buttons M1–M4
t–i, under which the kitchen timer pe-
riod should be saved. Its number is now
shown to the right of the "T".
6. Press the button MEM/AMS o once
again to conclude the saving.
Setting alarm times (Alarms 1 and 2)
You can programme two alarm times into
your kitchen radio.
- 7 -
/DOWN
 
1(/l