Single Slot Usb Cradle; Charging The Es400 Battery; Communication With Host Computer - Motorola ES400 User Manual

Single Slot USB Cradle

Use the Single Slot USB Cradle to charge the ES400 and to synchronize information between the ES400 and a
host computer.
NOTE The Host Adapter can only be connected to the ES400 and not the Single Slot USB cradle.

Charging the ES400 Battery

To charge the ES400 battery:
Connect the microUSB connector of the USB Rapid Charge Cable to the USB port on the back of the cradle.
1.
Connect the USB-A connector of the USB Rapid Charge Cable to the USB port on the power supply.
2.
Plug the power supply into an AC outlet.
3.
Single Slot USB Cradle Setup
Figure 12-2
Place the ES400 into the cradle.
4.
The ES400's LED indicates the status of the battery charging in the ES400. See
charging status indications. The 1540 mAh battery fully charges in less than three hours and the 3080 mAh battery
fully charges in less than six hours.

Communication with Host Computer

To communicate with a host computer:
Ensure ActiveSync is installed and configured on the host computer. See
1.
information.
Connect the microUSB connector of the USB Rapid Charge Cable to the USB port on the back of the cradle.
2.
Connect the USB-A connector of the USB Rapid Charge Cable to the USB port on the host computer.
3.
Accessories 12 - 3
Power Supply
USB Rapid Charge Cable
Table 2-4 on page 2-20
ActiveSync on page 12-11
for
for more