Table of Contents
Advertisement
Installation
Mounting the Camera (Continued)
Mounting the Camera Unit
1 Make a hole (Φ30 mm) in the ceiling using the template
provided
2 Mount the fall prevention wire for connecting the camera unit to
the ceiling
The fall prevention wire is not provided. Prepare a wire, taking into due
consideration the length, strength, pull and material (insulating).
① Remove the Fall Prevention Wire Mounting Screw on the bottom
of the camera unit to mount the fall prevention wire.
② Mount the fall prevention wire at a structurally strong location.
3 Mount the camera unit to the ceiling
Pull the cables from the ceiling and camera towards the lens as
illustrated in the diagram, align the (ñ) mark to the shooting direction
and mount the camera to the ceiling. Align the (ñ) mark upwards when
mounting the camera on the wall.
Camera unit
Shooting
direction mark
The screws for mounting the camera are not provided. Use a
Note
suitable type of screws according to the material of the
mounting location.
E-24
1
Φ30 mm
3
Φ4 mm x2 (not supplied)
.
Fall prevention wire
(not supplied)
2
8 mm
2 mm
Fall prevention
wire
6 mm and below
Φ12 mm and below
Φ4.1 - Φ6.5 mm
Advertisement
Table of Contents
