Table of Contents
Advertisement
Introduction
Operating Precautions
Storage and Location of Use
Do not install the camera in the following places.
- In a place with vapor or oil, for example in a kitchen.
- When the ambient temperature rises above or falls below the
acceptable range (from -10 f to 50 f)
- In a place at which corrosive gases are emitted.
- Near a source of radiation, X-rays, strong radio waves or
magnetism.
- In a place, such as vehicle installation, which is subject to vibration.
- In a place with excessive dirt.
Using this unit in the vicinity of the transmitting antenna of a radio or
TV, devices that emit strong electromagnetic waves such as a
transformer or motor, or wireless devices such as a transceiver or
mobile phone may give rise to noises in the image and changes in its
color.
Do not install in an environment where there is cold air or near the air
outlet of an air conditioner. The dome cover may become foggy as a
result of sudden temperature changes.
Set up this unit with the height of 16 m or lower.
Though this camera is IP66 compliant, there is no guarantee against
water seepage under any circumstances. (IP66 evaluation was not
conducted by UL.)
Maintenance
Clean the dome cover lens using a lens wiper cloth (or a tissue). For
tough stains, wipe with a neutral detergent diluted with water,
followed by wiping with a dry cloth. Do not use benzene or thinner to
wipe the camera. Doing so may melt the surface or cause it to fog.
Replace the IR LED unit every 3 years if it is used for 8 hours per
day.
Replace the silica gel every 2 years.
Energy Conservation
When the camera is not in use for a long time, turn off the power for
safety and energy conservation reasons.
E-12
Advertisement
Table of Contents
