Troubleshooting - Kenmore 29" Installation Instructions Manual

9, Remove door strike
Remove door strike from dryer cabinet and set aside.
hinge hole plugs
1 2, Remove door strike plug
Remove door strike plug. Insert the door strike removed in
Step 9 into hole and secure with screw. Insert door strike
plug into original door strike hole and secure with screw.
Use a small, flat-blade screwdriver to gently remove 4 hinge
hole plugs on left side of dryer cabinet. Transfer plugs into
hinge holes on opposite side of dryer cabinet.
1 1, Insert screws in hinge holes on
dryer cabinet
Close door and check that door strike aligns with door
catch. If it is needed, slide door catch left or right within slot
to adjust alignment.
TROUBLESHOOTING
See the "Use and Care Guide" or visit our website and reference
Frequently Asked Questions to possibly avoid the cost of a
service call.
NOTE: Two people may be needed to reinstall door.
Insert screws into the bottom holes on left side of dryer
cabinet. Tighten screws halfway. Position door so large end
of door hinge slot is over screws. Slide door up so screws
are in bottom of slots. Tighten screws. Insert and tighten top
screws in hinges.
17