Location Requirements - Kenmore 29" Installation Instructions Manual

Location Requirements
Explosion Hazard
Keep flarnnmable materials and vapors, such as
gasoline, away from dryer,
Place dryer at least 18 inches (460 mrn) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
You will need:
[] A location allowing for proper exhaust installation.
See "Venting Requirements."
[] A separate 30 amp circuit for electric dryers.
[] A separate 15 or 20 amp circuit for gas dryers.
[] If you are using power supply cord, a grounded electrical
outlet located within 2 ft. (610 mm) of either side of dryer.
See "Electrical Requirements."
[] A sturdy floor to support dryer and a total weight (dryer
and load) of 200 Ibs. (90.7 kg). The combined weight of a
companion appliance should also be considered.
[] Level floor with maximum slope of 1" (25 mm) under entire
dryer. If slope is greater than 1" (25 mm), install Extended
Dryer Feet Kit, Part Number 279810. If not level, clothes
may not tumble properly and automatic sensor cycles may
not operate correctly.
Do not operate your dryer at temperatures below 45°F (7°C). At
lower temperatures, the dryer might not shut off at the end of an
automatic cycle. Drying times can be extended.
The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes, or
sleeping quarters. Contact your local building inspector.
NOTE: No other fuel-burning appliance can be installed in the
same closet as a dryer.
installation clearances:
The location must be large enough to allow the dryer door to
open fully.
Most installations require a minimum 51/2"(140 mm) clearance
behind the dryer for the exhaust vent with elbow. See "Venting
Requirements."
Dryer Dimensions
433/8 n
(1102ram)
!
*26"
(660 tara)
(737A tara) (737_m}
43%" i
(1102 ram)
.273/4,'!_
(705rara)
_ 1- 223/'" _ _ .... JJ-_
....... 1 78raral 43w, i
(1102mm) _
(705 rara)½ ......
(737mm} (737mra)
C D
*Required spacing
A. Large opening side-swing door
B. Large opening side-swing door
C. Wide opening side-swing door
D. Wide opening hamper door
Installation Spacing
_=410,"max," _-_ in_*
_ I1_ mm (310cm)_-
[_ 24in:* -
-._ ._ (155cm) _
1"-_'t t<- 29" -_ _ 1" -_I"*F 273_"_5V2"I _-
(25rnm) (737mm) (25ram) (25rnrn)(705mrn) (140mm)
A B
A. Recessed area
B. Side view - closet or confined area
C. Closet door with vents
3]1,
(76 rnm)
-f
3H*
(76 ram)
T
*Required spacing
Installation spacing for recessed area or closet
The dimensions shown are for the minimum spacing allowed.
[] Additional spacing should be considered for ease of
installation and servicing.
[] Additional clearances might be required for wall, door,
and floor moldings.
[] Additional spacing of 1" (25 mm) on all sides of the dryer
is recommended to reduce noise transfer.
[] For closet installation, with a door, minimum ventilation
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are
acceptable.
[] Companion appliance spacing should also be considered.
6