Bosch LTC 2380 User Manual page 25

Digital Video Quad Processor
Setting the Time and Date Display
The monitor displays the date and time and the video from the recording device (REC OUT) in
the selected position. The new setting is applied when exiting menu mode.
1.
2.
3.
Configuring the Camera Sequence Setup
You use the SEQ SETUP menu to adjust the sequence dwell times of the four cameras in Full
screen and the Quad screen mode. You may program dwell times as SKIP or as 2, 3, 4, 5, 6, 7,
8, 9, 10, 20, 30, 50, 60, 80, or 99 seconds.
1.
2.
3.
4.
5.
Bosch Security Systems, Inc.
Press the Up and Down arrow keys and select DISPLAY.
TIME/DATE
(1) TIME FORMAT
(2) DATE FORMAT
(3) TIME/DATE SET
> (4) DISPLAY:TOP 1
(5) RETURN
Press the Return key to toggle through the display options:
– BOTTOM 1 (approximately 5% from the bottom of the monitor)
– BOTTOM 2 (approximately 10% from the bottom of the monitor)
– TOP 1 (approximately 5% from the top of the monitor)
– TOP 2 (approximately 10% from the top of the monitor)
– OFF
Press the Up and Down arrow keys and select RETURN; then press the Return key to exit
the TIME/DATE menu.
Press the MENU key to display the MAIN menu.
Press the Up and Down arrow keys and select SEQ SETUP; then press the Return key.
The unit displays the following menu:
SEQ SETUP
(1) CAMERA 1: 9 SEC
(2) CAMERA 2: 9 SEC
(3) CAMERA 3: 9 SEC
> (4) CAMERA 4: SKIP
(5) QUAD: 9 SEC
(6) RETURN
Press Up and Down arrow keys to move the cursor to the required camera.
Press the Return key to scroll through the dwell times. When you reach SKIP, press the
Return key to toggle through the sequence again.
Press the Up and Down arrow key and select RETURN; then press the Return key to exit
the menu.
User's Guide
Unpacking | en 21
F.01U.090.110 | 3.0 | 2010.04