Operating Peripheral Equipment Using The Remote Control - Panasonic TU-PTA500U Operating Instructions Manual

Operating peripheral equipment using the remote control

Programming The Illuminated Remote Control Using Access Codes
The remote control can be preset for other manufactures, by utilizing the REMOTE MODE SELECTION BUTTONS
for CABLE, DTV, VCR, RCVR (a Receiver or Amplifier), DVD (DVD, CD, LD) ,DBS and AUX (for Cassette Player
or a VCR2.)
(Details on remote control buttons to operate peripheral equipment
1. Setting up the remote using the numerical keys. (When code known):
1
POWER
+
CH
ACTION
VOL
CH
2
3
1 2
4 5
7 8
0
Note:
If an incorrect number is entered (or there is an incomplete entry after 28 seconds), the key illumination goes out (no
blink) and setting are unchanged.
Device
TV
VCR
CBL
DBS
RCVR
AUX
DVD
DTV
Press and hold the POWER and ACTION keys simultaneously for three full
seconds.
After 3 seconds, all the illuminated mode keys will begin to flash. Then let go of the
POWER and ACTION keys.
VOL
Press the desired mode key.
The mode key will illuminate steadily , all others will go out.
3 Enter the three digit set up code, by using the Remote Control Keyboard.
If the correct code is entered, the mode key will blink twice and then go out.
6
Now your remote is set for this code.
9
Operate
TV (Only Panasonic)
VCR (Preset)
Cable Boxes (Preset)
DBS Boxes (Preset)
RCVR (Preset)
Cassette Players, VCR2 (Preset)
DVD & LD & CD Player (Preset)
STB (Only Panasonic)
See page 55 to 57 and 58 to 60)
Default
Panasonic Code
Panasonic Code
Panasonic Code
Panasonic Code
Technics Code
Technics Cassette Players Code
Panasonic DVD Code
Panasonic Code
53