Table of Contents
Advertisement
If your network supports the Voice Privacy feature, your call will be
encrypted so that no one can access your call. Your phone always
attempts to use privacy mode. If your service provider's system does not
support this feature, or if the phone is on an analog channel, Voice
Privacy Off! displays and a warning tone sounds. You can turn this
warning tone on or off.
To enable/disable Privacy Tone,
Press
1
Select 6 Privacy Tone.
2
Select Enable or Disable and press OK softkey.
3
To enable/disable Send Caller ID,
Press
1
Select 7 Send Caller ID.
2
Select 2 Send (Normal). If Block Caller ID Code needs to be
3
changed, press Setup softkey. Enter Block Caller ID Code
and press OK left softkey.
To disable, press 1 Don't Send and press OK softkey.
4
Volume
To adjust volume of various sounds,
Press
1
Select 1 Ringer, 2 Msg Alerts, 3 Keypad, or 4 Earpiece
2
and press OK softkey.
Press up or down arrow to adjust volume and press OK
3
softkey. You can also press the right softkey to scroll through
the four types of volume controls.
Data Network
You can change your data network configuration in this menu. For
changes to take effect, you must exit and re-enter Data Mode by toggling
the
key. The default settings were set by your carrier and should only
be changed upon the instruction of your carrier.
46
and select 4 Preferences, 2 Call Setup.
and select 4 Preferences, 2 Call Setup.
and select 4 Preferences, 3 Volume.
Default setting = Disable
Default setting = Send (Normal)
Default setting = 4
Advertisement
Table of Contents
