Installation; Set Up The Player; Connect To Power Supply; Insert Battery (Remote Control) - Silvercrest SDV-702 User Manual

10

Installation

10.1 Set up the player
• Place your DVD player on a
sturdy, even surface.
• Fold out the support on the rear
of the unit and adjust for the best
viewing angle.
Note:
• For vehicle operation read the chapter Mounting on page 21.
10.2 Connect to power supply
For power supply, use the power adapter, car adapter, or batteries
(→ Power Supply, page 15).
10.3 Insert battery (remote control)
• Open the battery compartment
(55) at the bottom of the remote
control. Press and hold the
locking mechanism on the side
and pull out the battery holder at
the same time.
• Insert the supplied battery, making
sure to match the +symbol on the
battery with the same symbol in
the battery compartment.
• Push the battery support holder back into the battery
compartment (55).
Notes:
• The average life span of the battery is 1 year.
• Replace an exhausted battery with a battery of the same type
only (button cell CR2025 3 V).
• During extended periods of non-use, remove the battery from
the battery compartment.
• Also, observe the safety instructions for handling batteries on
page 9.
RELEASE RELEASE
+
17