Panasonic KX-TG8280FX Operating Instructions Manual page 54

TG8280FX(e).book Page 54 Tuesday, September 11, 2007 1:52 PM
Useful Information
Answering system
Problem
The unit does not
record new messages.
I cannot operate the
answering system with
the handset.
When I try to operate
the answering system
with the base unit,
{ANSWER ON} on the
base unit flashes for a
few seconds and I
cannot operate the
answering system.
I cannot operate the
answering system
remotely.
54
Cause & solution
L The answering system is not turned on for the line you
wish to record messages from. Select the desired line
or both lines, then turn the answering system on
(page 36).
L The recording time is set to "Greeting Only".
Select "1 Minute" or "3 Minutes" (page 42).
L The answering system is activated for both lines, and
the 1st caller is leaving a voice message. The 2nd
caller cannot leave a message, but the caller
information will be stored (page 34).
L If you subscribe to the voice mail service, messages
are recorded by your service provider/telephone
company not your telephone. Change the unit's
"Number of Rings" setting or consult your service
provider/telephone company (page 42).
L The base unit or another handset is being used. Wait
for the other user to finish.
L A caller is leaving a message. Wait for the caller to
finish.
L The handset is too far from the base unit. Move
closer.
L Another handset is being used. Wait for the other user
to finish.
L The answering system is being operated remotely
from outside. Wait for the caller to finish.
L You are entering the wrong remote access code. If
you forget the remote access code, store a new
remote access code and try again (page 40).
L Press each key firmly.
L The answering system is turned off. Turn it on
(page 41).
L You are using a rotary/pulse telephone. Try again
using a touch-tone phone.