Timer Recording - Toshiba D-VR18DTKB Owner's Manual

E9NG1BD_EN.book Page 41 Monday, April 7, 2008 5:54 PM

Timer Recording

Video VR
DVD-RW DVD-RW DVD-RW DVD-RW
VCR VCR VCR
DVD+R D D VD+R VD+R
You can set the unit to record up to 12 programmes,
up to a month in advance. Daily or weekly programme
recordings are also available.
• Be sure to set the clock before entering a timer
programming.
Insert a recordable disc or a tape with a
record tab.
1
In stop mode, press [TIMER PROG.].
"Timer Programming" list will appear.
2
Select "New Programme" using
[U / D], then press [ENTER / OK].
Timer Programming
Date Start
06/12 7:00
07/12 9:00
New Programme
• If there are 7 programmes or more, use
SKIP
B / F] to turn the page.
[
3
Enter the date using [U / D], then
press [P].
Each time you press [D] at the current date, the
timer recording date will change as follows.
e.g., 1st January
01/01
Daily
M-F (Mon.-Fri.)
W-SAT
W-FRI
W-SUN
31/01
Timer Programming
Date Start
--:--
01/01
REC To Mode
New Program
DVD SP
DVD-R DVD-R D D VD+R DVD+RW VD+RW W
0:00 THU 06/12
STTL
End CH
PDC
9:00 901
9:30 902
1/1
0:00 THU 06/12
End CH
--:-- 901 BBC1
PDC
OFF
SP 2:00
1/1
4
Enter the time to start and to end
using [U / D], then press [P].
5
Select the channel number to record
using [U / D], then press [P].
To record from the external input, select "AV1",
"AV2", or "AV3".
6
Select the recording media ("DVD"
or "VCR") using [U / D], then press
[P].
7
Select the recording mode using
[U / D], then press [P].
Refer to "Recording Mode" on page 34 for DVD or
page 85 for VCR.
8
For DVB channel recording:
Select "STTL" to "ON" or "OFF"
using [U / D].
If you set "STTL" to "ON", subtitle will be recorded
too.
• When analogue channel is selected, "PDC" will
be displayed instead of "STTL".
For analogue channel recording:
Select "PDC" to "ON" or "OFF"
using [U / D].
Refer to "PDC (Programme Delivery Control)" on
page 42.
• When DVB channel is selected, "STTL" will be
displayed instead of "PDC".
9
Press [ENTER / OK] when all
information required is entered.
Your programme setting is stored.
• To set another programme, repeat the steps 2 to
9.
• To exit, press [TIMER PROG.].
• When 2 or more programmes are overlapped,
"Timer programme overlapped" appears, and
the overlapped programme will be displayed in
blue. To correct the timer Programme, Refer to
"Checking, Cancelling or Correcting the Timer
Programming Information" on page 42.
10
Press [TIMER SET].
Timer Programming
0:00 THU 06/12
Date Start End
06/12 7:00 9:00
07/12 9:00 9:30
07/12 17:00 18:00
New Programme
The icon will appear on the front panel display
and the unit enters to the timer-standby mode.
STTL
CH
PDC
901
902
903
1/1
41
EN