Toshiba D-VR18DTKB Owner's Manual page 79

E9NG1BD_EN.book Page 79 Monday, April 7, 2008 5:54 PM
Dynamic Range Control (Default: ON) (DVD only)
Set to "ON" to make the dynamic range narrower.
Select a setting using [U / D], then
press [ENTER / OK].
Dynamic Range Control
ON
OFF
Your setting is activated.
"Dynamic Range Control" function is effective
only with analogue audio connection.
Note
• "Dynamic Range Control" function is available only
on discs recorded in the Dolby Digital format.
PCM sampling (Default: 48kHz)
Select a setting using [U / D], then
press [ENTER / OK].
PCM
48kHz
96kHz
Your setting is activated.
48kHz: If your amplifier / decoder is NOT compatible
with 96 kHz PCM, select "48kHz". Sound
recorded at 96 kHz is down sampled to
48 kHz.
96kHz: If your amplifier / decoder is compatible with
96 kHz PCM, select "96kHz". Sound is
sampled at 96 kHz.
Note
When playing back a disc with copyright protection:
• Even if you select "96kHz", the sound is down
sampled to 48 kHz.
Dolby Digital conversion (Default: Stream)
Select a setting using [U / D], then
press [ENTER / OK].
Dolby Digital
PCM
Stream
Your setting is activated.
PCM: Converts the Dolby Digital into PCM
(2 channel).
If your amplifier / decoder is NOT compatible
with Dolby Digital, set to "PCM".
Stream: Outputs Dolby Digital signals.
If your amplifier / decoder is compatible with
Dolby Digital, set to "Stream".
Hint
When playing back a DVD-RW disc recorded in VR
mode:
• If the audio source on a disc is in Dolby Digital
format, set "Dolby Digital" to "PCM" so that you can
switch to main audio (L), sub audio (R), or a
combination of both (L / R) using your amplifier /
decoder.
Settings for MPEG (Default: PCM) (DVD only)
Select a setting using [U / D], then
press [ENTER / OK].
MPEG
PCM
Stream
Your setting is activated.
PCM: Converts MPEG into PCM.
If your amplifier / decoder is NOT compatible
with MPEG, set to "PCM".
Stream: Outputs MPEG Audio signals.
If your amplifier / decoder is compatible with
MPEG, set to "Stream".
Settings for DTS (Default: ON) (DVD only)
Select a setting using [U / D], then
press [ENTER / OK].
DTS
ON
OFF
Your setting is activated.
ON: Outputs DTS signals.
If your amplifier / decoder is compatible with
DTS, set to "ON".
OFF: No DTS signal is output.
If your amplifier / decoder is NOT compatible
with DTS, set to "OFF".
3. Disc Menu Language (Default: English)
(DVD only)
Set "Disc Menu language".
Select a language using [U / D],
then press [ENTER / OK].
Disc Menu Language
English
Other
Your setting is activated.
4. Audio Language (Default: Original)
(DVD only)
Set "Audio language".
Select a language using [U / D],
then press [ENTER / OK].
Audio Language
Original
English
Other
Your setting is activated.
If "Original" is selected, the audio language is the
default of the inserted disc.
79
EN