Divx - Toshiba D-VR18DTKB Owner's Manual

E9NG1BD_EN.book Page 82 Monday, April 7, 2008 5:54 PM
1
Select the desired setting using
[U / D], then press [ENTER / OK].
Video Out
SCART (RGB)
Component (Progressive)
Component (Interlace)
• If your TV is compatible with progressive scanning
(576p/480p), connect the TV to the COMPONENT
VIDEO OUT jacks of this unit and select
"Component (Progressive)" and set your TV to the
progressive scan mode.
• If your TV is not compatible with progressive scan,
select "Component (Interlace)" for component
connection, or select "SCART (RGB)" for Scart
cable connection.
• Refer to pages 20 and 21 for more details.
Only if you select the "Component (Progressive)",
proceed to step 2. If you select "Component
(Interlace)" or "SCART (RGB)", your setting is
activated.
2
Using [L / P] to select "Yes". Press
[ENTER / OK].
Activating progressive scan:
Check your TV has progressive scan
and connect with component video cable.
NOTE:
If there is no picture or picture is
distorted after selecting "Yes",
wait about 15 seconds for autorecovery.
Activate?
Final confirmation window will appear.
3
Using [U / D] to select "Yes". Press
[ENTER / OK] within 15 seconds.
Confirm again to use progressive scan.
If picture is good, select "Yes".
Your setting is activated.
Note
• When changing "Video Out" setting ("SCART
(RGB)", "Component (Interlace)" or "Component
(Progressive)"), connect to the corresponding jack
on the TV. If the setting is changed, for example, to
"SCART (RGB)" while the COMPONENT VIDEO
OUT jacks are used to connect to the TV, a distorted
video signal may result.
82
EN
Yes No
Yes
No

DivX

®
1
In stop mode, press [SETUP]. Select
"General Setting" using [U / D],
then press [ENTER / OK].
2
Select "DivX" using [U / D], then
press [ENTER / OK].
General Setting
Playback
Display
Video
Recording
Clock
Channel
DivX
HDMI
Reset All
3
Select the desired item using
[U / D], then press [ENTER / OK].
DivX®VOD
DivX Subtitle
For "DivX®VOD", refer to page 56 for details.
DivX Subtitle (Default: OFF)
Select the desired setting using
[U / D], then press [ENTER / OK].
DivX Subtitle
OFF
English
French
Spanish
German
Italian
Swedish
4
When you finish with the setting,
press [SETUP] to exit.