Saving Settings - Siemens Gigaset SE361 WLAN User Manual

Note:
If you activate MAC access control, you must at least enter the PC from which you
are configuring the Gigaset SE361 WLAN. If you fail to do this, you will no longer
be able to access the user interface and an error message will be shown.
If, by mistake, you have denied all PCs access to the Gigaset SE361 WLAN you have
two options:
u
You can reset the Gigaset SE361 WLAN to the factory settings (see page 18).
u
You can connect a PC to the Gigaset SE361 WLAN using one of the LAN con-
nections (by cable). Since MAC access control only applies to PCs that are con-
nected "wirelessly", you can use this PC to change the configuration.
ì
To go to the next step, click on Next >.

Saving settings

On the next screen you close the wizard and save the settings. You will be informed of
any security risks that still exist.
ì
Click on Finish to close the wizard.
The settings will now be active on your Gigaset SE361 WLAN.
Note:
You must now configure the WEP or WPA key for your PC's wireless network adapter,
if this has been configured with other values. Once you have done this you can log in
to your Gigaset SE361 WLAN wirelessly again.
Security Setup Wizard
39