Forward gear outer race installer 1:
YB-06085
2. Install a new needle bearing into the for-
ward gear to the specified depth.
Bearing housing needle bearing
remover 1:
YB-06112
Driver handle (large) 2: YB-06071
Depth a:
1.20 ± 0.25 mm (0.05 ± 0.01 in)
Assembling the drive shaft
1. Install a new drive shaft bearing into the
drive shaft using a press.
6D81G11
Drive shaft and lower case
General pipe 1:
a = 33 mm (1.30 in)
b = 28 mm (1.10 in)
Installing the drive shaft
1. Install the forward gear, then the drive
shaft assembly, pinion, and pinion nut,
and then tighten the nut to the specified
torque.
Drive shaft holder 1: YB-06151
Pinion nut:
93 N·m (9.3 kgf·m, 68.6 ft·lb)
Installing the propeller shaft housing
1. Install the washer 1 and propeller shaft
assembly 2 into the propeller shaft
housing assembly 3.
2. Apply grease to a new O-ring.
1
S68S6410
6-20
1
2
3
4
5
6
7
8
9